Everbuild Stick 2 Rapid Epoxy Syringe 24ml Size With 50mm Hand Clamps

Features

• Material: Stone

DESCRIPTION AND USES
STICK 2 RAPID EPOXY ADHESIVE is an industrial strength two part clear adhesive which sets hard in just 10 minutes. RAPID EPOXY ADHESIVE is ideal for bonding metals, crockery, glass, wood, china, dry concrete, rubber, fabrics, crystal, jewellery/precious stones and various hard plastics. Due to its exceptional strength, this product may be drilled, sanded, machined and painted once fully cured.

APPLICATION
Ensure surfaces are clean, dry and are free from flaking material, dust, rust and grease. Roughen surfaces with sandpaper to improve adhesion.
Remove cap from centre of twin plunger and snap off tab from bottom of nozzles.
Use plunger to push out equal lengths of resin and hardener onto a clean disposable surface. Replace cap on nozzles,
Mix thoroughly for 30 secs to 1 minute with mixing stick provided. Mixed adhesive is usable for only 4 minutes. Only mix small quantities in one go.
Apply adhesive immediately to both surfaces. Assemble and hold/clamp until adhesive starts to cure. Note; Adhesive will cure faster at higher temperatures and conversely, slower at low temperatures. At 20`C, the adhesive sets hard in 10 minutes and is fully cured in 12 hours. RAPID EPOXY ADHESIVE is temperature resistant from -20 to +70`C.
Carefully remove any residual adhesive with a sharp knife before adhesive sets.

STORAGE: Store vertically in a cool, dry ventilated place between +5 and +25`C Protect from frost. Storage outside these parameters will dramatically reduce shelf life. Shelf life: 3 years from date of manufacture.

CLEANING: Clean uncured adhesive from tools etc with acetone or nail varnish remover, protecting surrounding surfaces. Cured adhesive must be mechanically removed.

LIMITATIONS
Do not use to repair items that will contain food and drink.
When replacing cap on bottom of nozzles, take care not to cross contaminate resin and hardener as this will prematurely cure adhesive in tubes.
As the manufacturer cannot know all the uses its products may be put to, it is the user s responsibility to determine suitability for use. If in doubt, contact Technical Services department for advice or refer to technical data sheet.

HEALTH AND SAFETY
Hazardous product! Resin based products can cause irritation, dermatitis or allergic reaction. Always read safety directions on the back of this container and wear suitable gloves/eye/face protection before use. Use in well-ventilated areas and store out of reach of children and animals. Avoid contact with skin and eyes.

The Roughneck heavy-duty plastic hand clips have a robust nylon construction.
The pivoting soft jaw pads protect workpieces and the hand clips feature a powerful spring mechanism.